Filter
Top Products
HOST INTERFACE Menu
81
Response Polarity
The Response Polarity parameter must be set to match the response polarity
of your host computer.
• Standard. Does not invert the response signal.
• Inverted. Inverts the response signal sent to the host computer.
Busy On Strobe
• Enable. Asserts a busy signal after each character is received.
• Disable. Asserts a busy signal only when the print buffers are full.
Latch Data On
Specifies whether the data is read on the leading or trailing edge of the data
strobe signal.
Prime Signal
• Enable. The parallel port will perform a warm start (reboot) if the host
asserts the Prime Signal.
• Disable. The parallel port will not perform a warm start (reboot) if the host
asserts the Prime Signal.
TOF Action
• Reset. A form feed is performed before a warm start when the prime
signal is asserted from the host. This setting is used only if the Prime
Signal parameter is enabled.
• Do Nothing. Nothing occurs before a warm start when the prime signal is
asserted from the host.
Buffer Size In K
Configures the amount of memory allocated for the Centronics parallel port
buffer. You can specify between 1 and 16 Kbytes, in 1-Kbyte increments.