Filter
Top Products
132
Chapter 3 LinePrinter Plus Emulation
LinePrinter Plus P-Series Emulation
Control Code 06
Control Code 06 defines the function of ASCII code hex 06 (ACK). You can
select an alternate line spacing of 6, 8 or 10.3 LPI.
Control Code 08
Control Code 08 defines the function of ASCII code hex 08 (BS). You can
define the code to output an elongated character or a backspace.
Define CR Code
This option controls the action of the printer when it receives a Carriage
Return code (hex 0D) from the host computer. If this feature is enabled, each
time the printer receives a Carriage Return, it inserts an additional Line Feed
code (hex 0A) into the data stream. Do not use this feature if the host
computer sends Line Feeds to the printer.
• CR = CR. Does not insert an extra Line Feed after each Carriage Return.
• CR = CR + LF. Inserts an extra Line Feed after each Carriage Return.
The next print position will be print position 1 of the next line.
Printer
Protocol
(from page 125)
Control Code
06
Control Code
08
Define CR
Code
Auto LF
Overstrike Define LF
Code
Select SFCC
EVFU Select Alt. Set 80-9F
Character Set
6.0 LPI
8.0 LPI*
10.3 LPI
Elongated*
Backspace
CR = CR*
CR = CR + LF
Disable*
Enable
Enable*
Disable
LF = CR + LF*
LF = LF
1*
(0-7F hex)
Enable*
Disable
Control Code*
Printable
(see page 135)
* = Factory Default
P-Series
SFCC d
Command
PSeries
Dbl High
Even dot plot*
Double high
Normal *
P3/4/6/9 Compat
FF Valid at
TOF
Enable*
Disable