Filter
Top Products
140
Chapter 3 LinePrinter Plus Emulation
Overstrike
Overstrike determines the action required when a line is printed over a
previous line because a carriage return was received without a line feed.
• Enable. Prints the second line on top of the first line.
• Disable. Replaces the characters from the first line with the second line.
Define LF Code
• LF = LF. Does not perform an automatic carriage return when a line feed
command is received. The next print position will be the current print
position of the next line.
• LF = CR + LF. Forces an automatic carriage return with each line feed
command received. The next print position is position 1 of the next line.
Printer Select
• Disable. Ignores the ASCII DC1 and DC3 control codes.
• Enable. Disables the printer when a DC1 control code is received, and
enables the printer when a DC3 control code is received.
Alternate Set 80-9F
• Control Code. Interprets data in the range of hex 80 through hex 9F as a
control code.
• Printable. Prints data in the range of hex 80 through hex 9F.
Character Set
Specifies a character set as shown in the page 141. To use one of these sets,
choose the desired group heading (such as European Sets) and press
ENTER. Then choose the desired set within that group (such as Roman 8)
and press ENTER. Both the group and the desired set will be starred to
indicate your selection. Character sets are shown in detail in the
Character
Sets Reference Manual
.
SFCC d Command
• Even dot plot. This option interprets Speed Command as even dot plot.
• Double high. This option interprets Speed Command as double high.
Select this option for backward compatibility.