Filter
Top Products
LinePrinter Plus Submenus
131
Margins - Physical Page
• Left Margin. Set in inches. Inch zero is defined as the far left edge of the
page, and column numbering increments from left to right.
• Right Margin. Set in inches. Inch zero is defined as the far right edge of
the page, and column numbering increments from right to left.
• Top Margin. Defined in inches, starting from inch zero at the top of the
page and incrementing from the top down.
• Bottom Margin. Defined in inches, starting from inch zero at the bottom
of the page and incrementing from the bottom up.
Perforation Skip
• Disable. Allows printing on page perforation.
• You may set up a skip-over margin of 1/2 inch, 2/3 inch, 5/6 inch, or 1
inch. For example, a skip-over margin of 1 inch allows a 1 inch margin at
the bottom of the page.
Forms Length
Forms length is the number of lines that can be printed on a page. You can set
forms length in inches, or as a function of the current LPI (lines per inch).
Form Width
The forms width can be specified in inches, millimeters, or as a function of the
current CPI (characters per inch). The forms width set should not exceed the
actual paper width.
Host Forms Length
• Disable. The default. Sets the form length equal to the PRINTER
CONTROL menu Page Length value.
• Enable. Sets the form length equal to the form length specified in a host
software command.
NOTE: When the optional CTHI (Coax/Twinax Host Interface) is selected
Host Forms Length must be set to Disable.