Filter
Top Products
Prepare The Printer
15
Installation and Removal
This section describes how to install the validator. To remove the
validator, reverse the steps of this procedure.
Prepare The Printer
1. Set the printer power switch to O (Off).
WARNING
Always unplug the printer power cord from the printer or
power outlet before doing any installation procedure. Failure
to remove power could result in injury to you and damage the
equipment. You will be instructed when to apply power.
2. Unplug the printer power cord from the printer or the AC power
source.
Factory Installation
If your printer has a factory installed validator, the ferrite, cable, wire
saddle, and grommet have already been installed. Go to “Install
The Brackets” on page 22.
Field Installation
If you are doing a field installation, you must install the ferrite, cable,
wire saddle, and grommet. Go to “Install The Ferrite” on page 16.