Filter
Top Products
Chapter 2 Configuring The Validator
54
Num Retry
This option allows you to set the number of times a form will be
reprinted before the printer stops. After you clear the error
message, the printer will print the same form or the next form,
depending on the setting for Max Retry Action (see “Max Retry
Action” below).
The options are 3, 4, and 5. The default is 5.
NOTE: This setting is utilized only when Validator Action is set to
Retry Form, Stop & Retry, or Rescan&Retry. See “Error
Action” on page 79.
Num Rescan
This option allows you to set the number of times a form will be
rescanned before the printer stops. After you clear the error
message, the printer will print the same label or the next label,
depending on the setting for Max Retry Action (see “Max Retry
Action” below).
The options are 1 to 5. The default is 1.
NOTE: This setting is utilized only when Validator Action is set to
Rescan, Rescan&Retry, or Rescan&Stop. See “Error
Action” on page 79.
Max Retry Action
This option determines what the printer will do with the current form
once the Num Retry or Num Rescan counter has been exhausted
(see “Num Retry” or “Num Rescan” above).
If Max Retry Action is set to Dump Form, after you clear the fault
the form will be dumped and printing will resume with the next form.
If Max Retry Action is set to Keep Form, after you clear the fault
printing will resume with the same form again. It will not attempt to
print the next form until the problem form has printed correctly.
NOTE: This setting is utilized only when Validator Action is set to
Retry Form, Stop & Retry, Rescan Form, Rescan&Retry, or
Rescan&Stop. See “Error Action” on page 79.