Filter
Top Products
Validator Reporting
45
7. Press ↓ and ↵ at the same time to lock the ↵ key, then press
PAUSE to take the printer offline.
8. Press PAUSE again to put the printer online.
NOTE: To disable the validator once it has been enabled, repeat
steps 1 to 8 and select Disable in step 5.
RFID Encoder
If you have an RFID encoder but are not encoding RFID tags, make
sure RFID Reader is set to Disable (in the RFID CONTROL menu),
otherwise the validation process will slow down considerably as the
RFID encoder attempts to scan for non-existent RFID tags.
Validator Reporting
After any completed print job, you can request a report from the
printer which describes the validation statistics since the printer was
turned on, or since the last data reset (for information on resetting
data, see page 47).
Requesting A Validator Report
This procedure prints a summarized validator report. (This report
also includes RFID data if the printer has an RFID encoder.)
1. Press the PAUSE key to take the printer offline.
2. If necessary, press ↓ and
↵ at the same time to unlock the
↵ key.
3. Press TEST PRINT. Printer Tests displays.
4. Press + until RFID/ODV Report displays.
5. Press
↵ to print the report.
6. Press ↓ and
↵ at the same time to lock the ↵ key, then press
PAUSE to take the printer offline.
7. Press PAUSE again to put the printer online.
Setting Auto Report
This function allows you to disable or enable an automatic validator
report printout after a batch job. The default is Disable.