Filter
Top Products
Attach The Grounding Wire And Power/Data Cable
25
4. Loosen the three upper bracket screws and route the
power/data cable through the cable channel in the upper
bracket, as shown in Figure 10.
5. Plug the RJ-11 connector end of the power/data cable into the
validator.
6. Route the power/data cable behind the bracket tab as shown in
Figure 10.
NOTE: If necessary, loosen the bracket mounting screws enough
to slip the power/data cable behind the bracket tab, then
retighten the bracket mounting screws.
7. Pull the cable to minimize the slack behind the lower bracket.
Push any excess slack through the grommet.
8. Tighten the three upper bracket screws.
Restore The Printer To Operation
1. Lower the media cover.
2. Engage the tabs on the bottom of the frame side cover in the
slots in the printer frame.
3. Rotate the cover into position.
4. Tighten the two captive screws. (Figure 2.)
5. Plug the AC power cord into the printer and the power source.
6. Set the printer power switch to | (On).