Printronix T5000R Printer User Manual


 
Chapter 1 Adjust The Scanning Beam
32
Summary Of Scanning Beam Adjustment
NOTE: If the printer does not have a tear bar with notches at the
ends, adjust the scanning beam so that the center of the
beam is approximately 0.06 inches (1.52 mm) from the
lower edge as shown in Figure 15.
Figure 15. Adjusting the Center of the Scanning Beam
To Move Beam
Down
To Move Beam
Up
To Rotate Beam
Clockwise
To Rotate Beam
Counterclockwise
Tighten top left
screw
Tighten both bottom
screws
Loosen bottom
right screw
Loosen bottom left
screw
or or or or
Loosen both
bottom screws
Loosen top left screw Tighten bottom
left screw
Tighten bottom
right screw
0.06 inches
(1.52 mm)