Filter
Top Products
Chapter 2 Configuring The Validator
46
You can determine the end of a batch job in two ways:
• by using an Execute command, or
• by enabling the Auto Report Time (see below).
To enable Auto Report:
1. Press to take the printer offline and place the printer in
Menu mode.
2. If necessary, press ↓ and
↵ at the same time to unlock the
↵ key.
3. If necessary, press until VALIDATOR displays.
4. Press ↓ until Auto Report displays.
5. Press + or – to scroll through the choices: Enable or Disable.
The default is Disable.
6. When Enable displays, press
↵ to activate Auto Report.
7. Press ↓ and
↵ at the same time to lock the ↵ key, then press
PAUSE to take the printer offline.
8. Press PAUSE again to put the printer online.
Setting Auto Report Time
This function allows you to set, in seconds, the timeout for the Auto
Report. If the printer is idle for the set number of seconds, an Auto
Report will be generated if Auto Report is set to Enable (see
“Setting Auto Report” on page 45.) The default is 1 second.
To set the Auto Report Time:
1. Press to take the printer offline and place the printer in
Menu mode.
2. If necessary, press ↓ and
↵ at the same time to unlock the
↵ key.
3. If necessary, press until VALIDATOR displays.
4. Press ↓ until Auto Report Time displays.
5. Press + or – to scroll through the choices: 1 to 10 seconds. The
default is 1 second.
6. When the desired number of seconds displays, press
↵ to set
the Auto Report Time.
.
.
.
.
.
.
.
.
.
.
.
.