Q-Logic 16HA Switch User Manual


 
Preliminary
SANbox-16HA Fibre Channel Switch
iv
59005-03 Rev. A Installer’s/User’s Manual
Power Switches 1-19
Test Mode Switch 1-19
Front Panel LEDs 1-20
Heartbeat LED (Yellow) 1-20
Switch Logic Power Good LED (Green) 1-20
Power Supply Fail LED (RED) 1-20
Over Temperature LED (Red) 1-21
Logged-In LED (Green) 1-21
Traffic LED (Yellow) 1-22
AC Input Power Connectors and Fuses 1-22
Switch Management Connector 1-22
Chassis Back 1-23
Power Supply(s) 1-24
Back Panel Lights 1-24
2
Installation
Introduction 2-1
Unpack 2-1
Place or Mount the Equipment 2-2
Shelf Mount 2-2
Rack Mount 2-2
Apply the IEC Class 1 Laser Information Label (If the installation is in Europe) 2-4
Install GBICs 2-5
Connect to AC Power 2-5
Switch Logic Power Good LED 2-7
Check the Power-On-Self-Test (POST) Results 2-7
Cable Fibre Channel Devices to the Switch 2-8
Public Devices 2-8
Private Devices 2-8
Mixing Public and Private Devices on the Same Loop. 2-9
Switch Ports 2-9
Tuning 2-9
Distance 2-10
Port Buffer Credits 2-10
Hot-Pluggable 2-11
Incorrect Cabling 2-11
Connections 2-11
Examples 2-12
Configure the Chassis 2-17
Configure the Ports 2-18
Fabric Ports 2-18
SL_Ports 2-18