Q-Logic 16HA Switch User Manual


 
Preliminary
GBIC
SANbox-16HA Fibre Channel Switch
Installer’s/User’s Manual 59005-03 Rev. A Removal/Replacement Procedures 4-5
2. Slide the GBIC into the port opening (the spring-loaded door will open as
you push the GBIC in). If you can only slide the GBIC in about an inch (2.5
cm) before it stops, you have the Keyway in the wrong position; flip the
GBIC over and try it again.
3. Push the GBIC in until the GBIC Latches snap into place. If you have a
GBIC that has bail-operated latches, make sure that the bail is rotated to the
latched position. This allows the latches to latch (refer to Figure 4-4).
4. Cable the port. Refer to Section 2 Installation for cabling instructions.