Filter
Top Products
Preliminary
Battery
SANbox-16HA Fibre Channel Switch
Installer’s/User’s Manual 59005-03 Rev. A Removal/Replacement Procedures 4-7
Replacement
If the Switch contains two Power Supplies, either supply is “Hot-Pluggable”. That
is, one supply can be replaced while the Switch is powered-up and operating as
long as the other supply is operating properly.
1. If you are placing a Power Supply in a Power Supply Bay that currently has a
Cover Plate on it, first remove the Cover Plate. Use a large flat-blade screw-
driver to turn each of the two Locking-Screws 1/4 turn counterclockwise.
If you are placing a Power Supply in a Power Supply Bay that has the Cover
Plate removed, go to the next step.
2. Orient the Power Supply as shown in Figure 4-6 and slide it all the way in to
the chassis. You will feel the connector on the back of the Power Supply mate
with the connector inside the Power Supply Bay. The flanges on the Power
Supply that contain the Locking Screws should be right up against the back
of the Power Supply Bay.
3. Push the Locking Screws into their respective holes. You may need to turn
them clockwise or counterclockwise in order to get them to go all the way in.
Then use a large flat-blade screwdriver to turn each of the two Locking-
Screws 1/4 turn clockwise.
Battery
The battery powers non-volatile memory used to store the Switch configuration.
The battery has a service life of 10 years. The battery is not field replaceable and
must be replaced by a repair depot.
WARNING:
Danger of explosion if battery is incorrectly replaced.
Replace only with the same or equivalent type recommended by the manufacturer.
Dispose of the used battery according to the manufacturer’s instructions.
WARNUNG:
Bei unsachgemäß ausgetauschter Batterie besteht Explosionsgefahr.
Die Batterie nur mit der gleichen Batterie oder mit einem äquivalenten, vom
Hersteller empfohlenen Batterietyp ersetzen.
Die gebrauchte Batterie gemäß den Herstelleranweisungen entsorgen.
AVERTISSEMENT:
Danger d’explosion si le remplacement de la pile est incorrect.
Ne remplacer que par une pile de type identique ou équivalent recommandé par le
fabricant.
Jeter la pile usagée en observant les instructions du fabricant.