Filter
Top Products
A – Command Line Interface
Set Setup Command
59226-00 B A-59
A
Eth0NetworkMask Ethernet subnet mask address.
Eth0GatewayAddress Ethernet IP address gateway.
AdminTimeout Amount of time in minutes the switch waits before ter-
minating an idle Admin session. Zero (0) disables the
time out threshold. The default is 30, the maximum is
1440.
InactivityTimeout Amount of time in minutes the switch waits before ter-
minating an idle Telnet command line interface ses-
sion. Zero (0) disables the time out threshold. The
default is 0, the maximum is 1440.
LocalLogEnabled Enables (True) or disables (False) the saving of log
information on the switch. The default is True.
RemoteLogEnabled Enables (True) or disables (False) the recording of
the switch event log on a remote host that supports
the syslog protocol. The default is False.
RemoteLogHostAddress The IP address of the host that will receive the switch
event log information if remote logging is enabled.
The default is 10.0.0.254.
NTPClientEnabled Enables (True) or disables (False) the Network Time
Protocol (NTP) client on the switch. This client
enables the switch to synchronize its time with an
NTP server. This feature supports NTP version 4 and
is compatible with version 3. An Ethernet connection
to the server is required and you must first set an ini-
tial time and date on the switch. The synchronized
time becomes effective immediately. The default is
False.
NTPServerAddress The IP address of the NTP server from which the
NTP client acquires the time and date. The default is
10.0.0.254.
EmbeddedGUIEnabled Enables (True) or disables (False) the SANsurfer
Switch Manager Web applet. Changing this parame-
ter to False while the applet is running will terminate
the applet. The default is True.
Table A-14. System Configuration Settings (Continued)
Entry Description