Filter
Top Products
Quatech SDS User’s Manual Installing the device drivers
Figure 19 - Network Connectivity Test screen
Figure 20 shows the Network
Connectivity Test prompt. This
prompt informs you that the
Wizard is ready to check the IP
connectivity of the SDS.
Step Procedure Description
Step 24 Press the Next button to run the IP
connectivity test.
The Retrieving Unit Configuration pop-
up box displays briefly.
Continue with □ Step 25.
Figure 20 - Retrieving Unit Configuration pop-up box
Step Procedure Description
Step 25 Depending on whether the test passes or
fails, one of two screens displays:
¾ TCP/IP Network Configuration
Parameters
¾ Network Connectivity Test Failed
If the test passes, the TCP/IP Network
Configuration Parameters screen
displays. Continue with □ Step 26.
If the test fails, the Network Connectivity
Test Failed screen displays.
Go to
□ Step 55.
Figure 21 shows the Retrieving
Unit Configuration pop-up box.
This box shows the configuration
retrieval progress and closes
when it is complete.
July 2005 940-0183-153 Page 25