Filter
Top Products
Installing the device drivers Quatech SDS User’s Manual
Alternative installation steps
This section supplements the basic installation procedure by taking
you through alternative installation scenarios. It then directs you to
the appropriate step in the basic procedure.
Note: This section has steps
that are used less frequently
than those in the preceding
section.
Figure 24 - Reconfigure the Serial Device Server screen
Figure 25 shows the current
configuration parameters for
the SDS. You can accept these
parameters by pressing Next or
you can change them by
pressing Reconfigure SDS.
Step Procedure Description
Step 30 The Reconfigure the Serial Device Server
screen lets you change the SDS’
configuration so that it can operate in its
permanent location.
¾ If you do not need to change the
configuration, press the Next button
to continue.
¾ To change the configuration, click the
Reconfigure SDS button.
If your SDS is temporarily attached to
your computer’s NIC port, you may need
to attach it to a different subnet when
you do a permanent installation.
The Serial Device Server is Configured
for a Remote Subnet screen displays.
Continue with □ Step 31.
The Internet Protocol (TCP/IP)
Properties dialog box displays.
Go to
□ Step 32.
Page 30 940-0183-153 July 2005