Filter
Top Products
M3062PT3-RPD-E User’s Manual 2. Setup
REJ10J0040-0600 Rev.6.00 July 01, 2006 Page 29 of 104
Figure 2.7 Switch settings for the self-check (factory-settings)
2.7.2 If an Error is Detected in the Self-check
If the self-check does not result normally, check the following.
(1) Whether the emulation pod and PC4701 are connected properly
(2) Whether the proper firmware has been downloaded
(3) Whether the switch settings of this product are the factory-settings
IMPORTANT
Notes on Self-check:
z Perform the self-check while not connecting the user system.
z If the self-check does not result normally (excluding target status error), the emulation pod may be damaged.
Then contact your local distributor.
BYTE
HOPENL
SW1
CNVss
H
OPEN
L
SW2
Xout
OP Xout
SW3
P86/Xcout
P86/XC OP
SW4
P87/Xcin
P87 Xcin
SW5
VDDIO
VCC1
VCC2
JP2
VCC1>VCC2
=
A18_SEL
1M
JP1
4M
M30620T3-PRT board
(factory-settings)
(factory-settings)
(factory-settings)(factory-settings)
(factory-settings)
(factory-settings)
(factory-settings)