Filter
Top Products
M3062PT3-RPD-E User’s Manual 2. Setup
REJ10J0040-0600 Rev.6.00 July 01, 2006 Page 47 of 104
2.9.5 Jumper Switches JP1 and JP2 on the M30620T3-PRT (MCU-dependent board 1)
Table 2.5 Switch settings of the M3062PT3-RPD-E (3)
Signal Switch Setting Description
A18_SEL
1M
JP1
4M
(factory-settings)
Always use this setting.
A18_SEL JP1
A18_SEL
1M
JP1
4M
Do not use this setting.
VDDIO
VCC1
VCC2
JP2
VCC1>VCC2
=
(factory-settings)
2.7[V] ≤ Vcc1=Vcc2 ≤ 5.5[V]
VDDIO JP2
VDDIO
VCC1
VCC2
JP2
VCC1>VCC2
=
4.8[V] ≤ Vcc1 ≤ 5.2[V] and 2.7[V] ≤ Vcc2 < Vcc1
CAUTION
Note on Switch Settings:
z Always shut OFF power before changing switch setting.