Filter
Top Products
M3062PT3-RPD-E User’s Manual 5. Troubleshooting
REJ10J0040-0600 Rev.6.00 July 01, 2006 Page 98 of 104
(2) Editor (Source) Window is Not Displayed at Debugger Startup (User System Connected)
Table 5.2 Checkpoints of errors when starting up the emulator debugger (user system connected)
Error Checkpoint
ERROR 16005:
Can't connect with the target.
(1) Check the connection between the PC4701 and host machine.
See the PC4701 User's Manual.
(2) Check that the PC4701 is powered on.
See the PC4701 User's Manual.
(3) Check that all switch settings on the rear of the PC4701 and
interface cable settings of the emulator debugger match.
See the PC4701 User's Manual and the emulator debugger user's
manual (online manual).
ERROR 16211:
The version of the emulator and the
firmware on the target are not same.
(1) Check the connection between the PC4701 and this product.
See “2.4 Connecting the PC4701” (page 23).
(2) Download the proper firmware.
See "2.6 Downloading Firmware" (page 27).
(3) Choose the proper MCU file in the Init dialog box.
See the emulator debugger user's manual (online manual).
(4) Check that the descriptions in the MCU file are correct.
See "3.1 Making an MCU File" (page 50).
ERROR 16215:
Cannot communicate with the debugging
monitor. Execute the RESET command.
(1) Check the connection between the PC4701 and this product.
See “2.4 Connecting the PC4701” (page 23).
(2) Check that the reset pin of the user system is at “H” level.
See the MCU specifications.
(3) Check that CNVSS is held low.
See the MCU specifications.
(4) Check that the oscillator circuit of the emulation pod is oscillating
properly.
See "2.9.3 Selecting Clock Supply" (page 41).
ERROR 16014:
Communication ERROR.
Can't accept data.
(1) Check that the oscillator circuit of the user system is oscillating
properly.
See "2.9.3 Selecting Clock Supply" (page 41).
(2) Check that the PC4701 LEDs at startup show normal operation.
See "2.5.3 LED Display When the Emulator Starts Up Normally"
(page 26).
ERROR 16231:
There was sent undefined data from the
emulator.
Check that the emulator debugger has not been started up without
shutting down the PC4701.
See "4.6 IMPORTANT: Note on Quitting the Emulator Debugger"
(page 92).