Filter
Top Products
Selectable Options
These instructions assume youÕve followed the steps above under ÔSetting an OptionÕ
and the machine is asking if you want to change one of the options listed here.
¥ Contrast Level
_
Select the expected normal contrast level. DARKEN and LIGHTEN
will be based on this normal setting.
Enter a number from 1 through 7 on the number keypad. The higher number entered,
the darker normal contrast selected. To adjust the contrast level for PHOTO, you can
enter 1, 4, or 7.
¥ Paper Size
_
Select the paper size you will use for the recording paper.
Press 1 to use letter (LTR) size, 2 to use A4 size, 3 to use legal (LEG) size paper.
¥ Reduction Rate (ADJUST REDUCTION)
_
When receiving or copying a document as
long as or longer than the paper installed in your machine, the machine can reduce the
data of the document to fit on your recording paper size. You can select the reduction
rate as shown below. The machine will reduce the data in vertical according to the
selected reduction rate.
Enter the number of selection you desire.
1 : LTR LTR (4% ~ 10%)
2 : LTR A4 (0% ~ 3%)
3 : A4 LTR (9% ~ 14%)
4 : A4 A4 (3% ~ 8%)
5 : LEG LTR (25% ~ 28%)
6 : LEG A4 (20% ~ 23%)
7 : LEG LEG (4% ~ 8%)
8 : 85%
9 : 80%
0 : 75%
¥ Printing Bottom Area (PRINT BTM. AREA)
_
If there is image within 12.7mm from
the bottom margin, you can select the machine to print the image at the bottom area as
much as possible, or to reduce the page to fit in the effective recording area.
Press 1 to print the image at the bottom area. The image quality might be poor.
Press 2 to reduce the page to fit in the effective recording area.
¥ Rings to Answer (RING COUNT)
_
You can select the number of times your machine
rings before answering an incoming call. If you are using your machine as both a
telephone and a fax machine, we suggest you set the ring count to at least 4 to give you
time to answer.
Enter a number using the number keypad.
¥ Remote Receive Code (REMOTE RCV. CODE)
_
The remote receive code allows you
to initiate fax receive from an extension phone plugged into the EXT.LINE jack. If you
pick up the extension phone and hear fax tones, enter the remote receive code and the
fax will start receiving. The password is preset to 9 at factory.
Enter the desired code 0 to 9 on the number keypad.
¥ Confirmation Report (MESSAGE CONFIRM)
_
A confirmation report shows whether
the transmission was successful or not, how many pages were sent, etc.
Press 1 to print out a confirmation report automatically each time you send a fax.
Press 2 to print out a confirmation report automatically only when an error occurs.
Press 3 to turn off this feature.
SPECIAL FEATURES
C
HAPTER
S
IX :
S
PECIAL
F
EATURES
6.9
216 mm
12.7 mm
6.5mm
6.5mm
C-Chapter 6(US) 4/16/98 8:42 AM Page 6.9