Filter
Top Products
6-32
SYSTEM SETTINGS
Contents
OPERATION PANEL (ADMINISTRATOR)
Network Settings
Network settings are described below. Select the [Network Settings] key to configure the settings.
IPv4 Settings
When using the machine on a TCP/IP (IPv4) network, use
this setting to configure the IP address of the machine.
The settings are shown below.
IP Address*
Enter the IP address of the machine.
IP Subnet Mask*
Enter the IP Subnet Mask.
IP Gateway*
Enter the IP Gateway address.
DHCP
Use this setting to have the IP address obtained
automatically using DHCP (Dynamic Host Configuration
Protocol). When this setting is enabled, it is not
necessary to manually enter an IP address.
* In these settings, press the key when entering dot
separators.
IPv6 Settings
When using the machine on a TCP/IP (IPv6) network, use
this setting to configure the IP address of the machine.
The settings are shown below.
Enable IPv6 Protocol
Enable this setting.
DHCPv6
Use this setting to have the IP address obtained
automatically using DHCP (Dynamic Host Configuration
Protocol). When this setting is enabled, it is not
necessary to manually enter an IP address.
Manual Address
Enter the IP address of the machine.
Prefix Length
Enter the prefix length (0 to 128).
Default Gateway
Enter the IP Gateway address.
Enable TCP/IP
To use the machine on a TCP/IP network, this setting
must be enabled.
Enable NetWare
To use the machine on a NetWare network, this setting
must be enabled.
Enable EtherTalk
To use the machine on an EtherTalk network, this
setting must be enabled.
Enable NetBEUI
To use the machine on a NetBEUI network, this setting
must be enabled.
Reset the NIC
This returns all "Network Settings" to the factory default
settings.
Ping Command
Use this function to check if the machine can
communicate with a computer on the network.
Specify the IP address of the desired computer and
select the [Execute] key.
When entering an IPv4 IP address, press the key to
enter dot separators. A message will appear indicating
whether or not the computer responded.
When settings are changed, the changes will take effect after the machine is restarted. To restart the machine see
"TURNING THE POWER ON AND OFF" (page 1-14) in "1. BEFORE USING THE MACHINE ".
• If the machine will be used on a TCP/IP network, be
sure to enable "Enable TCP/IP
" below.
• If DHCP is used, the IP address assigned to the
machine may change automatically. If the IP
address changes, specify the printer port setting
again and then print.
• If the machine will be used on a TCP/IP network, be
sure to enable "Enable TCP/IP" below.
• If DHCP is used, the IP address assigned to the
machine may change automatically. If the IP
address changes, specify the printer port setting
again and then print.
• In an IPv6 environment, the machine can use LPD
or IPP protocol.