Filter
Top Products
Operations 25
Operating the cutter (con’t)
Replacing cutter blade (con’t)
9. Tilt and slide the cutter blade from the cutter
holder.
10. Install the new cutter blade to the cutter
holder.
a. Ensure that the cutter unit is still in the
centered position.
b. Push the new cutter blade into the cutter
holder until the blade snaps into position.
11. Press the button associated with RESET.
Note: RESET moves the cutter unit to the
right, even if the cutter blade has NOT been
successfully installed. Should the RESET
button be accidentally pressed before
successful installation, manually move the
cutter holder to the center and properly install
the cutter blade as specified in step 10b.
12. The operation panel displays: "Close the
covers.” Close them.
13. The final message is "Done. Press
½
key.”
This will put the printer in READY status.