Filter
Top Products
34 Supplies
Feed roller knob
Loading and removing media (con’t)
Loading media in the printer (con’t)
11. Rotate the feed roller knob toward you. Continue
to forward the media until you hear a beep from
the printer. The printer will sense the new
media’s leading edge. Ensure that there is even
tension and no wrinkles on the media.
12. Close the printer’s top cover. The printer will
start initializing, and you should hear activity as
it checks and positions the newly loaded media
roll.
After completing its self-test, the printer will
forward some of the newly loaded media
through the print path and then cut it. This
assures that the media has a clean-cut leading
edge when printing.
13. Examine the cut edge of the media to verify that
the cutter is properly set and is cutting the media
cleanly. If it is not a clean cut, change the
printer’s cutter setting to match the media type.
Refer to the
Operations
chapter as described in
Media
type
.
14. Ensure the printer is online and ready to receive
the next print job.
15. Set the media type and attributes at the
operations panel. Refer to the
Operations Pane
l
Menu
section.
This completes installation of a new media roll in
the printer.
Feed roller knob