Filter
Top Products
Supplies 31
Replacing the waste ink bottle (con’t)
When to replace the waste ink bottle
The waste ink bottle should be replaced when the waste ink bottle is
filled with the waste ink.
* WASTE BOTTLE FULL
/NOT INSTALLED
SEE USER GUIDE
[ER: 4621]
For cases where the waste ink bottle is full, the LCD will display
the
Waste Bottle Full
message.
The amount of waste ink in the waste ink bottle is measured by
the waste ink bottle’s weight. The waste ink bottle tray acts as a
scale and must move freely to properly measure the amount of
waste ink in the bottle and prevent waste ink over-flow.
Caution: If the printer continues to run without detecting the
change in the waste ink bottle’s weight, the waste ink bottle
could overflow and contaminate the printer and floor.
Replacement procedures
The steps to replace waste ink bottle are:
Procedures
1. Locate the waste ink bottle on the right rear side
of the printer.
2. Pick up the waste ink bottle and tilt it to remove
the bottle from the waste ink bottle tray.
3. Place the waste ink bottle into the disposable
plastic bag.
3. Properly dispose of the used waste ink bottle.
4. Set the new waste ink bottle on the waste ink
bottle tray. Ensure that the bottle is properly
seated on the tray before continuing.