Filter
Top Products
36 Supplies
2. Rotate the end cap rearward to rewind the
media onto the media roll.
3. Remove the media roll from the feeder.
4. Remove the end caps from both ends of the
media roll by turning the light green locking knob
in the RELEASE direction and then pulling the
caps away from the media roll.
Tip: Use a low-adhesion tape, such as masking
tape, to keep the media from unrolling after it is
removed from the printer. A high-adhesion tape
can damage the leading edge of the media
when it is removed.
5. Store the media roll in the horizontal position,
being careful not to
dent or otherwise damage
the exposed ends of the media roll.
Caution: The ends of media roll are vulnerable
to mechanical damage whenever the media roll
end caps are removed. Use caution while
handling media as damaged media can damage
the printer or cause printing problems. Never
store unprotected media rolls upright.
Supply storage
To keep your supplies in good condition, you should always observe
the following storage requirements.
Ink bottle storage
When storing ink bottles:
Select a cool location with good ventilation.
1. Do not place ink bottles directly on the floor.
2. Use ink within 18 months of date of manufacture.
3. Avoid storing ink bottles where:
−
The bottles are exposed to direct sunlight.
−
The bottles are exposed to high temperature or humidity.