Filter
Top Products
123
3. Check if the speaker connection to the M/B is correct.
4. Make sure the software setup is correct.
The sound is working in my system, but when I play CD music from the
CD-ROM, I do not get any sound. What is wrong?
This is because the 3-wire audio cable from the CD-ROM to the on-board
CDIN1 connector in the M/B is not connected. See manual for location of
CDIN1.
The sound and everything else works fine except that the recorder and
microphone do not work. What is wrong?
1. Please go to sound properties and check if the recorder and
microphone in the are enabled.
2. Check if Microphone is ok.
3. If you are using 4 channel or 6 channel audio but you are not using
the SPDIF card, the microphone and line-in channels will be used
for audio output.
Hard disk/FDD/ CD-ROM issues
My Western digital HDD is not detected during boot-up
Change the jumper settings to cable select or single.
Sometimes the system finds my CD-ROM, sometimes not
1. Check CD-ROM if it is working properly.
2. The power supply might not have enough wattage to support all the
peripherals. If your system has other peripherals connected, like
CD-RW, extra HDD, etc. disconnect them.
When I boot up my new computer I got "floppy boot failure" and the
LED on the floppy stays on
Make sure the red wire of floppy ribbon cable goes to Pin1 on the floppy
drive side (don't trust the "key lock" or "notch") and use the end-connector
of the cable (don't use middle one).