Filter
Top Products
BIOS Setup Utility
SY-KT600 DRAGON Ultra
79
SuperIO Device (Continue)
Setting Description Note
Disabled
3F8/IRQ4 Default
(port 1)
2F8/IRQ3 Default
(port 2)
3E8/IRQ4
2E8/IRQ3
Onboard
Serial Port 1 /
Serial Port 2
Auto
Choose serial port 1 & 2's I/O
address.
Do not set port 1 & 2 to the same
address except for Disabled or
Auto.
IrDA
ASKIR
Normal
The second serial port offers these
InfraRed interface modes.
Default
UART Mode
SCR SCR mean Smart Card Reader.
If [UART Mode Select] is set to [IrDA]/[ASKIR]
Half Default
UR2 Duplex
Mode
Full
Choose [Half] or [Duplex] to set
UR2 in half duplex mode or full
duplex mode respectively. Refer
to your IR device specifications to
select the suitable mode.
Disabled
378/IRQ7 Default
278/IRQ5
Onboard
Parallel Port
3BC/IRQ7
Choose the printer I/O address.
SPP Default
EPP
ECP
Parallel Port
Mode
ECP+EPP
The mode depends on your
external device that connects to
this port.
If [Parallel Port Mode] is set to [ECP] or [ECP+EPP] mode
3 Choose DMA3 Default
ECP Mode use
DMA
1 Choose DMA1