Filter
Top Products
.
..
L
-.
,,
..
13. Turn the platen knob to feed the paper forward until it comes out from
under the top cover.
14. Move the bail lever back to close the bail.
15. Check that the paper is feedingin flat, then raise the other clamp lever
to lock the other sprocket unit.
16. Replace the rear cover.
Hold it tilted upward and insert the two tabs
at the bottom into their slots. Then rotate the cover forward, pressing
down on the thumb pads on the left and right to snap it into place.
17. Mount the paper guidein the horizontal position shown in Figure 1-12,
so that it will-separatethe printed from the unprinted paper.
. . . .
lgure 1-12. Mounting the paper guide tor Tanrolaterms
Now you are ready to switch power on and print.
Paper parking
After loading fanfold paper; you do not have to unload it when you
want to print on a single sheet. The printer will “park” it for you if you
follow the procedure below.
1. Paper parking starts with power ON, fanfold paper loaded in printing
position, the release lever up, and the bail lever back.
2. Press the On Line switchon the control panel to set the printer off-line
(On Line indicator otT).
11