Filter
Top Products
5-14 Ultra Enterprise 6000/5000/4000 Systems Manual—November 1996
5
Figure 5-8 Disk Drive with Ejector Drive Retainer Open
3. If a new drive is to be installed, proceed to the next section.
If the drive is not to be replaced, replace the Disk board as described in
Section 5.5.2, “Installing a Board”.
5.5.3.2 Installing a Disk Drive
1. Inspect the shipping container upon receipt of your drive, and look for
evidence of damage.
If the carrier’s agent is not present when the container is opened, and the
contents are damaged, keep all contents and packing materials for the
agent’s inspection.
2. If there is no evidence of damage, carefully remove the drive from the
shipping container.
Save the carton and the packing material for possible later use.
3. Place the antistatic mat on a table or work surface.
4. Attach a grounding wrist strap.
Refer to the documentation that came with your ESD kit.
5. Remove the disk drive from its protective packaging.
Hold the disk drive by the edges, near the middle of the drive. Keep the
drive vertical until you lay it on the ESD mat.
Latch