Filter
Top Products
12-10 UltraEnterprise 6000/5000/4000 Systems Manual—November 1996
12
12.4 Reading Boot Messages
♦ Use the boot software messages to verify the presence of options in the
system. After POST completes the system self-test, a message similar to
the following will appear on your screen. The message lists hardware
detected in the system.
Note – The following screen display is only an example. The actual message
displayed on the screen will vary with the software running on the system.
If there is no terminal on this system, you must check the system status by
inspecting LEDs on the front panel. See Figure 12-8 and Figure 12-9.
Figure 12-8 Front Panel Status LEDs (Cabinet Server)
16-slot Ultra Enterprise 6000, Keyboard Present
OpenBoot -.- FCS, --- MB memory installed, Serial #---.
Ethernet address -:-:--:-:--:--, Host ID: ------.
DC power (green)
Fault (yellow)
System running
(green)