Sun Microsystems 5000 Switch User Manual


 
4-2 Ultra Enterprise 6000/5000/4000 Systems ManualNovember 1996
4
4.1 Handling Boards and Assemblies
Caution The chassis AC power cord must remain connected to ensure a
proper ground.
Caution The I/O boards, their modules, and cards have surface-mount
components that can be broken by flexing the boards.
To minimize the amount of board flexing, observe the following precautions:
Hold the board only by the edges near the middle of the board, where the
board stiffener is located. Do not hold the board only at the ends.
When removing the board from an antistatic bag, keep the board vertical
until you lay it on the Sun ESD mat.
Do not place the board on a hard surface. Use a cushioned antistatic mat.
The board connectors and components have very thin pins that bend easily.
Do not use an oscilloscope probe on the components. The soldered pins are
easily damaged or shorted by the probe point.
Transport the board in an antistatic bag.
Be careful of small parts located on the component side of the board.
Be careful not to drag boards across surfaces as board components are easily
damaged.
Caution The heatsinks on the board can be damaged by incorrect handling.
Do not touch the heatsinks while installing or removing the board. Hold the
board only by the edges. If a heatsink is loose or broken, obtain a replacement
board.
Caution – When inserting the board into slot 4 or slot 10 of a 16-slot card cage,
lift the board slightly to avoid damage to the centerplane connectors.
Caution – The heatsinks on the board can be damaged by improper packaging.
When storing or shipping the board, ensure that the heatsinks have sufficient
protection.
!
!
!
!
!