Sun Microsystems 5000 Switch User Manual


 
Safety and Tools 11-5
11
Caution Improper handling by unqualified personnel can cause serious
damage to this equipment. Unqualified personnel who tamper with this
equipment may be held liable for any resulting damage to the equipment.
Persons who remove any of the outer panels to access this equipment must
observe all safety precautions and ensure compliance with skill level
requirements, certification, and all applicable local and national laws.
All procedures contained in this document must be performed by qualified
service-trained maintenance providers.
Caution Before you begin, carefully read each of the procedures in this
manual. If you have not performed similar operations on comparable
equipment, do not attempt to perform these procedures.
11.4 Tools Required
This list represents the minimum of tools and test equipment required to
service the system cabinet:
Screwdriver, slotted, 3/16 inch
Screwdriver, Phillips #2
Screwdriver, Phillips #1
Hex driver, M-4
Hex driver, 3/16 inch
Hex driver, 9 mm
Hex driver, 3/32
Wrench, 13 mm
DIP/IC extraction tool
ESD mat
Grounding wrist strap
Needlenose pliers
!
!