Filter
Top Products
Preparing for Service 13-7
13
13.3.6 Side Panels
To remove the left and right side panels:
1. Loosen two slot-head captive screws near the panel base.
2. Tilt the panel bottom out.
3. Lift the panel up until free of the tabs at the top of the chassis.
Set the panel aside.
Figure 13-4 Removing the Side Panels
To replace the side panels:
1. Place the panel against the cabinet so the notches on the panel inside
align with tabs at the chassis top.
2. Lower the panel into place and allow it to hang flush against the chassis.
3. Tighten the two captive screws at the panel base.
Captive screws
Side panel
Chassis tabs
Panel notches