Filter
Top Products
8-22 Sun Fire V120 and Netra 120 Server User’s Guide • December 2001
check Resets monitoring to report all failures.
If a monitored component has failed, the LOM device will not
continue to report the same failure. To check the status of the
component, for example, after attempting to fix it, issue the check
command. This updates the status of all monitored components.
console This command takes you out of the LOM shell and back to the Solaris
prompt. It returns control of the serial connection to the console.
environment Displays the temperature of the server and the status of the fans, the
power supply, the over-temperature monitors, the supply rails and
circuit breakers, the alarms, and the fault LED.
faulton Sets the Fault LED to On.
faultoff Sets the Fault LED to Off.
help Displays the list of LOM commands.
loghistory Displays all the events in the LOM device’s Event Log.
logout This command is for use by named users you have set up with
password access to the LOM device. It returns them to the LOM user
login prompt.
poweron Powers the server on.
poweroff Powers the server down to standby power mode.
reset Resets the server.
show model Displays the server model.
show hostname Displays the server name (this command is equivalent to the Solaris
uname -n command).
show eventlog Displays the LOM device’s event log.
The event log is the list of the last 10 events to have been stored in the
LOM device. The most recent event is the one at the bottom of the list.
show escape Displays the current LOM escape sequence.
show Displays all the information available with the show command.
useradd Adds a user to the LOM device’s list of permitted users.
userdel Deletes a user from the LOM device’s list of permitted users.
usershow Displays the details of a named user’s LOM account.
userpassword Sets or changes a user’s password.
userperm Sets the permission levels for a named user.
version Displays the version number of the LOM device.
TABLE 8-2 LOM Commands (Continued)
Command Effect