Filter
Top Products
7-4 Sun Fire V120 and Netra 120 Server User’s Guide • December 2001
5. Specify whether you need IPv6 enabled, then follow the instructions on the
screen.
6. Specify whether you want to to enable the Kerberos Security mechanism, then
follow the instructions on the screen.
7. When prompted, give a password (if any) for users logging in as root.
When you have provided the information the system needs, it will boot.
7.2.2 Powering On the Server for the First Time
Without Having Its Details Registered
Follow the instructions in this section if you do not have a Name Server configured
on your network.
Before following the instructions in this section, read them to find out what
information the system prompts you for when you start it for the first time.
1. Connect the server to the power supply but do not power it on.
2. Set up a serial connection to the Serial A/LOM port and also a connection to at
least one Ethernet hub (as described in Chapter 6).
3. At the lom> prompt, type the following command to power on the server:
For more information about the lom> prompt and the commands that are available
from it, see Chapter 8.
4. When prompted, specify the type of terminal you are using to communicate with
the Sun Fire V120 or Netra 120 server.
5. When prompted to indicate whether you want the server to be networked, answer
Yes.
6. Specify whether the IP address is to be configured by DHCP.
7. Specify which of the Ethernet ports you intend to use as the primary Ethernet
connection.
For the port labeled NET0, specify eri0. For the port labeled NET1, specify eri1.
8. Specify a Host Name for the server.
lom> poweron