Sun Microsystems V120 Server User Manual


 
1-8 Sun Fire V120 and Netra 120 Server User’s Guide December 2001
1.6 The Fans Inside the Sun Fire V120 and
Netra 120 Servers
The Sun Fire V120 and Netra 120 servers contain four fans. These are monitored by
the LOM device, so you can use the Lights-Out Management (LOM) commands to
check their status. For more information, see Chapter 8 and Chapter 9.
For a diagram showing the position of the fans inside the server, see “Identifying
Server Components” on page 4-6.
1.7 Tools You Need for Installation
An 8-mm wrench (for assembling the rackmounting).
A small flat-head screwdriver (for levering the grilles when installing hard disks).
An ESD pad and an antistatic wrist strap and earthing point (to protect the
components of the system if you need to install any hardware options).
A No. 2 Phillips screwdriver.
For Netra 120 servers that are stacked on top of each other in a rack, you need to
use a right-angled two-hole lug. Use a UL/CSA-approved component, such as the
one supplied by Thomas & Betts (part number: 54204-UB). You will also need a
crimping tool, such as the Thomas & Betts crimping tool (part number: TBM 5-S).