Sun Microsystems V120 Server User Manual


 
7-2 Sun Fire V120 and Netra 120 Server User’s Guide December 2001
7.1 Preparing to Configure the Server
To perform the initial configuration of the Sun Fire V120 or Netra 120 server, set up
a serial connection using the port labeled Serial A/LOM on the server’s back panel
(see Chapter 6). Make sure you have the server’s power cord(s) connected (see
Chapter 6).
7.1.1 Using a Terminal Server
To access the Sun Fire V120 or Netra 120 server from a Sun workstation through a
terminal server, open a terminal session on the Sun workstation and type:
For example, for a Sun Fire V120 server connected to port 10000 on a terminal server
whose IP address is 192.20.30.10, you would type:
7.1.2 Configuring From a Terminal or Workstation
To access the server from a dumb terminal, set up a connection between the
terminal and the server.
To access the server from a Sun workstation that is directly connected to the
server, set up the connections between the devices, then open a terminal session
and type:
The tip command above assumes that your console is using its ttya port. If you
later configure your console to use its ttyb port, you will need to type the following
to set up a tip session:
# telnet IP-address-of-terminal-server port-number
# telnet 192.20.30.10 10000
# tip /dev/term/a -9600
# tip /dev/term/b -9600