Filter
Top Products
xviii Sun Fire V120 and Netra 120 Server User’s Guide • December 2001
Part II Remote and Local Management
Chapter 8 describes how to use the Lights-Out Management (LOM) shell to power
the server on and off or reset it remotely. It also describes how to use this shell to
view status information about the server’s fans, power supply, supply rails,
operating temperature, and internal circuit breakers.
Chapter 9 describes how to use the LOM-specific Solaris commands to monitor and
manage the system. This chapter also explains how to configure the LOM device to
restart the server automatically after a system lockup.
Part III Troubleshooting and Maintenance
Chapter 10 lists some problems that you might encounter while setting up or using
the server and tells you how to solve them. It also describes the server’s LEDs.
Chapter 11 lists the field-replaceable units (FRUs) that you can order for your server
and tells you how to install them.
Part IV Appendixes
Appendix A tells you how to install and remove Hard Disk Drives from the server
without shutting the operating system down.
Appendix B provides information on re-installing Solaris and the Lights-Out
Management (LOM) software.
Appendix C describes the parameters you can configure in the LOM driver
configuration file.
Appendix D provides the locations and the factory default settings of the jumpers
on the system board.
Using Solaris Commands
This document does not contain information on basic Solaris commands and
procedures such as shutting down the system, booting the system, and configuring
devices.
See one or more of the following for this information:
■ AnswerBook2™ online documentation for the Solaris operating environment
■ Other software documentation that you received with your system