3-8 Sun Fire V120 and Netra 120 Server User’s Guide • December 2001
FIGURE 3-7 Routing the Wires Out of the Strain Relief Housing
3. Insert the tie wrap into the bottom portion of the strain relief housing (see
FIGURE 3-8).
FIGURE 3-8 Securing the Wires to the Strain Relief Housing
4. Loop the tie wrap over the wires and back out of the strain relief housing and
tighten the tie wrap to secure the wires to the strain relief housing (see
FIGURE 3-8).
5. Position the top portion of the strain relief housing so that the three prongs on the
top portion fit into the openings in the DC connector, and push them together
until they snap into place (see
FIGURE 3-9).