Filter
Top Products
6
Using Color
6-8
Phaser 240 Drivers and Utilities
Using downloadable utility files for selecting color corrections
If you are not using a Tektronix Phaser 240 driver, use the downloadable
utility files to make color correction settings. Refer to the table on page 6-6
for information on locating downloading instructions for your
computer type.
The color correction utility files operate only in conjunction with the
printer’s DIP switches.
Note
You shouldn’t have to adjust the printer’s switches.
The following switch positions are the printer’s factory default
settings. However, if you think the printer’s switches may have
been adjusted, see your system administrator for information.
For a downloaded color correction utility file to take effect, the printer’s
switches must be in the following positions before a utility file is downloaded
to the printer:
■ Switches 1, 2, and 4 down
■ Switch 3 up
If you have to adjust the switches: The printer’s switches are located inside
the rear panel door. Refer to the Phaser 240 Color Printer User Manual for
instructions on locating the printer’s switches.
Other characteristics of printer switches:
■ When shipped from the factory, the printer is set with Switch 3 up,
enabling the Vivid Color selection. Later, if you download a color
correction utility file to the printer, a new setting takes affect.
■ If Switch 3 is placed in the down position, all color corrections are
turned off, and no color correction utility files can be downloaded.
■ If Switch 3 is placed in the up position again, then the last known
color correction takes affect, such as a downloaded utility file if
one had previously been sent to the printer.