Filter
Top Products
7
Using Fonts
7-4
Phaser 240 Drivers and Utilities
Decompressing the fonts
Note
Do not decompress fonts directly into the System Folder; they
must be properly installed after they have been decompressed onto
your hard disk.
1.
Insert the Macintosh Driver and Printer Utilities diskette into your
computer's disk drive.
2.
Double-click on the Phaser ScreenFonts.sea archive file.
3.
At the Self-Extracting Archive dialog box, click Continue.
4.
In the dialog box, select the drive where you want the
decompressed fonts saved.
5.
At the prompt Install software as: you are asked to name
the folder where you want the decompressed fonts to reside. Use
either the default folder name listed in the edit box or type in the
name you want for the folder. Then click Save.
6.
At the Installation was successful dialog box, click Quit.
The decompressed fonts are saved in the folder you specified.
Installing the decompressed fonts
If you are using System Software 6.0.7:
Use the Font/DA Mover (located on your Apple system software diskettes)
to install the fonts you want from the Phaser Screen Fonts suitcase.
If you are using System Software 7.0 and later:
Drag the fonts you want from the Phaser Screen Fonts suitcase to the closed
System Folder icon. At the alert message, click OK; the fonts are
automatically installed in the proper place.
Select the printer font you want to use within an application and see the
same font on the screen.