Toshiba e-STUDIO451c Copier User Manual


 
June 2005 © TOSHIBA TEC e-STUDIO281c/351c/451c ADJUSTMENT
3 - 51
3
(3) Assembling carriage wires
Winding the wire around the wire pulley:
Pull the Ø3 ball terminal located at the center of the wire into a hole on the wire pulley.
One end of the wire with a hook attached comes to the outside.
Wind the wires around the wire pulleys of the front and rear sides. The number of turns to be
wound are as follows:
- 2 turns toward the opposite side of the boss
- 4 turns toward the boss side
Notes:
Pay attention to the followings when the wires are wound around the pulleys:
Do not twist the wire.
Wind the wires tightly so that they are in complete contact with the surface of the pulleys.
Each turn should be pushed against the previously wound turn so that there is no space
between them.
Fig.3-18
After winding the wires around the pulleys, attach the wire holder jigs not to loosen the wires.
2 turns 4 turns 2 turns4 turns
No space between turns
Ball terminalBall terminal
Color: Black
Color: Silver
Hook
Hook
[
Rear
][
Front
]