Toshiba e-STUDIO451c Copier User Manual


 
e-STUDIO281c/351c/451c ERROR CODE AND SELF-DIAGNOSTIC MODE June 2005 © TOSHIBA TEC
2 - 10
CC20 Finisher related ser-
vice call
Communication error between finisher and saddle
stitcher: Communication error between finisher con-
troller PC board and saddle stitcher controller board
[MJ-1023/1024]
Ch.5.1.16
CC30 Stack processing motor abnormality: The stack pro-
cessing motor is not rotating or the stack delivery
belt is not moving normally. [MJ-1022]
Ch.5.1.16
CC40 Swing motor abnormality: Swing motor is not rotat-
ing or swing unit is not moving normally. [MJ-1023/
1024]
Ch.5.1.16
CC50 Horizontal registration motor abnormality: Horizon-
tal registration motor is not rotating or puncher is
not shifting normally. [MJ-1023/1024 (when MJ-
6004 is installed)]
Ch.5.1.16
CC60 Punch motor abnormality: Punch motor is not rotat-
ing or puncher is not shifting normally. [MJ-1023/
1024 (when MJ-6004 is installed)]
Ch.5.1.16
CC80 Front alignment motor abnormality: Front alignment
motor is not rotating or front aligning plate is not
moving normally. [MJ-1022]
Front aligning plate motor abnormality: Front align-
ing plate motor is not rotating or aligning plate is not
moving normally. [MJ-1023/1024]
Ch.5.1.16
CC90 Upper stack tray lift motor abnormality: The upper
stack tray lift motor is not rotating or the upper stack
tray is not moving normally. [MJ-1022]
Ch.5.1.16
CCA0 Lower stack tray lift motor abnormality: The lower
stack tray lift motor is not rotating or the lower stack
tray is not moving normally. [MJ-1022]
Ch.5.1.16
CCB0 Rear jogging motor abnormality: The rear jogging
motor is not rotating or the rear jogging plate is not
moving normally. [MJ-1022]
Ch.5.1.16
CCD0 Stack ejection motor abnormality: Stack ejection
motor or stack ejection roller is not rotating nor-
mally. [MJ-1023/1024]
Ch.5.1.16
CCE0 Paper trailing edge assist motor abnormality: Paper
trailing edge assist motor is not rotating or paper
trailing edge assist is not moving normally. [MJ-
1023/1024]
Ch.5.1.16
CCF0 Gear changing motor abnormality: Gear changing
motor is not rotating normally. [MJ-1023/1024]
Ch.5.1.16
CE00 Communication error between finisher and punch
unit: Communication error between finisher control-
ler PC board and punch controller PC board [MJ-
1023/1024 (when MJ-6004 is installed)]
Ch.5.1.16
CE10 Image control related
service call
Image quality sensor abnormality (OFF level): The
output value of this sensor is out of a specified
range when sensor light source is OFF.
Ch.5.1.17
CE20 Image quality sensor abnormality (no pattern level):
The output value of this sensor is out of a specified
range when the image quality control test pattern is
not formed.
Ch.5.1.17
CE40 Image quality control test pattern abnormality: The
test pattern is not formed normally.
Ch.5.1.17
CE50 Temperature/humidity sensor abnormality: The out-
put value of this sensor is out of a specified range.
Ch.5.1.17
CE90 Drum thermistor abnormality: The output value of
the drum thermistor is out of a specified range.
Ch.5.1.17
Error code Classification Contents Troubleshooting