Filter
Top Products
June 2005 © TOSHIBA TEC e-STUDIO281c/351c/451c TROUBLESHOOTING
5 - 19
5
[E090] Image data delay jam
[E550] Paper remaining on the transport path
Relation between the jamming area and the corresponding sensors/covers
(If a jam is occurring in the ADU, LCF or PFP, check the board in each unit.)
1) Remove the paper remained in front of the registration sensor.
2) Check if the error is cleared by turning the power OFF and then back ON.
3) Check if the connectors connecting the SYS board, SLG board and PLG board are dis-
connected.
4) Check if the connectors of the HDD are disconnected.
5) Check if the harnesses connecting the SYS board, SLG board and PLG board are open-
circuited.
6) Replace the HDD, SYS board, SLG board and PLG board.
Open the cover of the unit/area whose picture is flashing on the control panel.
Is there any paper on the transport path?
È
YES Æ Remove the paper.
NO
Is the sensor in the jamming area working?
(Perform the input check: Refer to the following table)
|
|
|
|
|
|
|
|
|
È
NO Æ 1) Check if the connector of the sensor is disconnected.
2) Check if any of the connectors on the LGC board is disconnected.
3) Check if the connector pins are disconnected or the harnesses are open
circuited.
4) Check if the conductor pattern on the LGC board is short circuited or open
circuited.
5) Replace the sensor.
6) Replace the LGC board.
YES
Replace the LGC board.
Jamming area Cover Sensor Test Mode/Input check
Registration area Jam access cover Registration sensor 03-[FAX]ON/[9]/[E]
Upper drawer feed sensor 03-[FAX]ON/[3]/[H]
Exit area Fuser cover Exit sensor 03-[FAX]OFF/[7]/[H]
ADU ADU ADU entrance sensor 03-[FAX]OFF/[8]/[H]
ADU exit sensor 03-[FAX]OFF/[8]/[G]
Bypass unit Bypass unit Bypass feed sensor 03-[FAX]ON/[9]/[D]
Feeding area
(equipment)
Side cover Lower drawer feed sensor 03-[FAX]ON/[3]/[G]
LCF LCF side cover LCF feed sensor 03-[FAX]OFF/[5]/[G]
PFP PFP side cover PFP upper drawer feed sensor 03-[FAX]OFF/[2]/[D]
PFP lower drawer feed sensor 03-[FAX]OFF/[4]/[D]
Bridge unit Bridge unit Bridge unit transport sensor-1 03-[FAX]ON/[0]/[C]
Bridge unit transport sensor-2 03-[FAX]ON/[0]/[A]
Finisher Finisher door Sensors in the finisher -