Filter
Top Products
e-STUDIO281c/351c/451c TROUBLESHOOTING June 2005 © TOSHIBA TEC
5 - 40
[EAC0] Transport delay jam
MJ-1024
Is there any paper remaining on the transport path in the finisher, saddle stitcher section or
equipment?
È
YES Æ Remove the paper.
NO
Is the connector J708 on the finisher controller PC board disconnected?
Is the harness connecting the finisher controller PC board and inlet sensor (PI33) open cir-
cuited?
È
YES Æ Connect the connector securely. Replace the harness.
NO
Is the inlet sensor working properly? (Check the movement of the actuator.)
|
|
|
È
NO Æ 1) Connect the connector of the sensor securely.
2) Attach the actuator securely if its shaft is out of place.
3) Replace the sensor.
YES
Replace the finisher controller PC board.