Filter
Top Products
3.32 SETUP 3 Tests and Diagnostics
7. Configuration
This option lets you set the device configuration.
All Devices BIOS sets all devices.
Setup by OS Initializes devices, which is needed to load an operating
system. Operating system initializes other devices.
NOTE: (1) When using installed OS, selecting “Setup by OS” is recommended.
(2) When executing test programs, be sure to select “ALL Device”. And after
the test end, select “Setup by OS”.
8. Drives I/O
This option displays the address and interrupts level for hard disk drive and optical
disk drive. It is for information only and cannot be changed.
Built-in HDD
1 This cannot be changed.
If HDD 1 is not installed, "No Drive" is displayed.
Built-in HDD
2 This cannot be changed.
If HDD 2 is not installed, "No Drive" is displayed.
CD-ROM
This cannot be changed. This is not displayed when a
drive is not built-in.
9. PCI Bus
This option displays the interrupt level for the Card Bus in the computer. It is for
information only and cannot be changed.
PCI BUS = IRQ10, IRQ11
10. Display
This group of options configures the computer’s display.
(a) Power On Display
This option is used to select the display when booting up.
Auto-Selected Selects an external monitor if one is connected.
Otherwise it selects the internal LCD. (Default)
LCD+AnalogRGB Selects both the internal LCD and the external CRT for
simultaneous display.
3-114 [CONFIDENTIAL] QOSMIO G20 Maintenance Manual (960-511)