Filter
Top Products
2.10 DVD-ROM, CD-RW/DVD-ROM and DVD Multi Drive Troubleshooting 2 Troubleshooting Procedures
2.10 DVD-ROM, CD-RW/DVD-ROM and DVD Multi Drive
Troubleshooting
This section describes how to determine if the DVD-ROM, CD-RW/DVD-ROM or DVD
Multi drive in the Slim Select Bay is functioning properly. Perform the steps below starting
with Procedure 1 and continue with the other procedures as required.
Procedure 1: Diagnostic Test Program Execution Check
Procedure 2: Connector Check and Replacement Check
Procedure 1 Diagnostic Test Program Execution Check
The CD-ROM/DVD-ROM test program is stored in the Diagnostics Disk.
For the test, prepare a test DVD-ROM and CD-RW Media (branch).
Then insert the Diagnostics Disk in the computer’s floppy disk drive, turn on the computer
and run the test. Refer to Chapter 3, Tests and Diagnostics, for more information about the
diagnostics test procedures.
If any errors occur while executing the CD-ROM/DVD-ROM test, go to Procedure 2.
TECRA M1 Maintenance Manual (960-436) 2-45