Toshiba tecra m1 Laptop User Manual


 
3.6 Keyboard Test 3 Tests and Diagnostics
To check only the USB mouse, follow the procedures below:
Connect the USB mouse to the computer’s USB connector.
Next, set up the computer’s hardware as follows:
PERIPHERAL
Internal Pointing Device = Simultaneous
USB Legacy Emulation = Enabled
Then, perform the Pointing Stick Diagnostic Test and make sure:
The cursor moves in the direction that you move the USB mouse.
The display reverses when you click the right button or left button
To stop this test, press the two IPS buttons on the computer at the same time.
(You cannot use the USB mouse to stop the test.)
Subtest 05 USB Test
This Subtest checks USB. The USB TEST Module (ZD0003P01) and USB
Cable (ZD0003P02) must be connected to the computer.
The following message will appear. Select a port to test and press Enter.
Test port number select (1:Port0, 2:Port1, 3:Port2) ?
If the test ends successfully, OK is displayed. If nothing is displayed, there
may be a problem with the USB port. Check the wraparound connection and
repeat the test.
Subtest 07 InTouch/Presentation key
When this subtest displays messages shown below in order, press the
corresponding button.
NOTE: This subtest must be completed within 10 seconds.
Press [ InTouch ] key
Press [ Presentation ] key
TECRA M1 Maintenance Manual (960-436) 3-19