Filter
Top Products
4 Replacement Procedures 4.6 Slim Select Bay Module
4.6 Slim Select Bay Module
Removing the Slim Select Bay Module
To remove the slim select bay module, follow the steps below and refer to figures 4-7 and 4-
8.
CAUTION: The slim select bay module can become hot with use. Be careful when
removing the module.
1. Remove the following screw securing the slim select bay module from the screw hole
for lock, and tighten the removed screw in the screw hole for release. (The slim select
bay is unlocked.)
• M2.5×4 FLAT HEAD screw ×1
2. While sliding the latch toward the arrow direction in the figure, slide the slim select
bay module outward to disconnect it from PJ1511 on the system board.
Figure 4-7 Removing the Slim select bay module (for example DVD-ROM drive)
4-18 TECRA M1 Maintenance Manual (960-436)