Filter
Top Products
3.2 Executing the Diagnostic Test 3 Tests and Diagnostics
3. Select the option you want to execute and press Enter. When “1-SYSTEM TEST” is
selected, the following message will appear:
SYSTEM TEST XXXXXXX XXXX DIAGNOSTIC TEST VX.XX
[Ctrl]+[Break] : test end
[Ctrl]+[C] : key stop
SUB-TEST : XX
PASS COUNT: XXXXX ERROR COUNT: XXXXX
WRITE DATA: XX READ DATA : XX
ADDRESS : XXXXXX TATUS : XXX
SUB-TEST MENU :
01 - ROM checksum
02 –
03 -
04 – Fan ON/OFF
05 – Gerserville
06 - Quick charge
07 - DMI read
08 - DMI write
09 - CPU Temperature
99 - Exit to DIAGNOSTIC TEST MENU
NOTE: The menu displayed by your computer may be slightly different from the
one shown above.
4. Select the desired subtest number from the subtest menu and press Enter. The
following message will appear:
TEST LOOP : YES/NO
Selecting YES increases the pass counter by one, each time the test cycle ends and
restarts the test cycle.
Selecting NO returns the subtest menu to the main menu after the test is complete.
TECRA M1 Maintenance Manual (960-436) 3-5